Athena CDI/ HT coil for Piaggo/ Gilera engines.

No rev-limit, standard Piaggio CDI's are restricted to 10,000rpm.

If your...

This will restrict the revs of your engine to a preset limit determined by yourself and can therefore be used as a speed...

CDI/ Coil unit for Piaggio/ Gilera mopeds.

This is identical to the genuine Piaggio part except the rev restriction has been removed. (The...

This rev limiter is a clever way to restrict your scooter. It engages a rev limiter automatically whenever the engine is turned off. To...

Indicator/ flasher relay. Available in 2 pin and 3 pin

LED indicators bulbs are much lower wattage than conventional bulbs. Consequently...

An easy alternative to installing an LED indicator relay, These resistors are simply connected in parallel to each indicator, creating...

Starter relays for almost all mopeds.

Choice of connector pin layout, check photos to select yours.

For use when you have fitted LED indicators.

LED indicators use much less power than regular bulbs and can cause the flasher unit to not...

8-pin voltage regulator/ rectifier for Piaggio/ Gilera mopeds and scooters.

This is the 8 pin version which incorporates a built-in flasher...

Motoforce replacement stator assembly for Piaggio purejet mopeds.
This will fit all the Piaggio 50cc fuel injected moped engines including...

Voltage Rectifier/ Regulator for Piaggio/ Gilera engines. Incorporates flasher unit.

This item is genuine Piaggio (8 connections).

With PVL, Stage6 have managed to find a distinguished and competent partner to develop and manufacture there ignition. PVL has supplied...

Koso 90 degree, 150cm exhaust gas temperature sensor, for use with the Stage6/ Koso EGT gauges.

These temperature sensors allow measurement of the cylinder temperature of air-cooled engines using the Stage6 Rev Counter & ...

Koso temperature sensor to fit Koso DB02's and Stage6 speedos.
This is for Piaggio liquid cooled engines and has a M10 x 1.0mm...

Engine temperature sensor for Piaggio/ Gilera engines.
Thread M10x1.0mm

approx resistances:
20deg = 2,500 ohm
40deg = 1,300 ohm
75deg = 380...

Universal Automatic Choke Unit

Replacement automatic electronic choke unit for most 50cc scooters/ mopeds.

Fits: Piaggio/ Aerox, Minarelli,...

Bargain replacement part from Motoforce for missing or faulty chokes, suitable for all 12mm, 17.5mm and 22mm PHVA and PHVB Dellorto...

Universal on/ off SPDT toggle switch with cover and LED on/off indicator light.

For use with any custom application which requires an on/...

High-gloss aluminium pilot-style switch panel equipped with 2 control lamps, push button, toggle switch and toggle switch with cover.

Can...

Genuine Piaggio replacement ignition lock switch. Fits most Piaggio/ Gilera models including Zip, NRG, Stalker, Typhoon.

*These are colour ...

Genuine Piaggio/ Gilera indicator switch.

Genuine Piaggio/ Gilera high and low beam switch.
Mounts into the front handlebar panel. 

Additionally fits all Runner 125 2 stroke and...

Unlike most lanyards this kill switch from Scooter Attack features a magnetically attached switch which is very easily removed and...

TNT Tuning lanyard kill switch.

This is ideal for race scooters. Attach it to yourself and it will of course kill the engine as soon as the...

TNT Tuning switch gear. If your going to convert from your stock bars to downhill ones then this is the kit for you.

Controls:
On /...

High quality Motoforce racing HT lead.Motoforce Part No. MF12.00005

7.5mm diameter Naraku HT cable.

This is sold in 1 metre lengths and comes in a bright racing orange colour.

Waterproof NGK spark plug resistor cover.
Maximum heat resistance.
Maximum voltage resistance.

NGK spark plugs. Select the sparkplug you want from the drop down box above.

High quality replacement red rubber spark plug cap for liquid cooled mopeds - universal fitting.

For full waterproofing loop a small cable...

Fits almost everything air-cooled.

Suitable for the spark plug tip shown in the photo (or just unscrew the spark plug tip from...

Selection of high quality Motoforce spark plug caps.
All connectors have a 90° angle and are made of rubber or plastic.Motoforce Part ...

TNT Tuning HT cable. Universal 530mm long

5 metre lengths of electrical wire for general purpose moped wiring.

Available in choice of three different colors ...

In order to protect your scooters electric components, most electric circuits are equipped with a fuse!
If too much current flows, a metal...

Inline fuse holder with fuse, Comes with spare 15A fuse.

Motoforce inline fuse holder.
Any new circuits or electrical devices you connect to your moped must be connected through a fuse in order to...

These Motoforce connectors are a handy and tidy solution for all custom electrical work on your scoot.
No matter whether you want to modify...

Lithium 4L-BS battery, this is a very high quality low maintenance long lasting sealed battery.
Can be recharged to 90% capacity in just 6...

LUCAS Moped Battery - All scooter batteries are either supplied with an acid pack or are pre-filled and sealed.

We have tried a large...

Oxford essential battery charger/ optimiser for 12v batteries.

Recovers deeply discharged batteries.

Automatically assesses and...

6v/12v Scooter Battery charger.

Comes with Crocodile clips and Battery terminal connectors.

Replacement Piaggio/ Peugeot starter moter. Fits most Piaggio/ Gilera/ Peugeot models including Zip, NRG, Stalker, Typhoon,...

Replacement starter motor for Piaggio/ Gilera Purejet fuel injection mopeds, complete with wiring.
Also fits Piaggio 4-stroke scooters.

This...

Motoforce brings you this 12V power socket, for powering external devices with a cigarette lighter plug, e.g. for mobile phone charger or...

Very high quality universal 12v water pump made by Bosch.
Suitable for permanent long term use.

In scooter racing the mechanical water pumps...

Genuine Piaggio electronic speedo drive.

Ignition spark tester with adjustable spark gap testing.

This is the only type of spark tester worth buying.

This invaluable tool allows...