Oil pump for Yamaha Aerox/ Minarelli engines.

The standard oil pump mixes at maximum 2% or 50:1 ratio. Some performance cylinder kits are...

Genuine Yamaha water pipe clips for Yamaha Aerox/ Minarelli liquid cooled mopeds.

These are the little clips which secure the tiny heating...

Water pump grommet for Aerox/ Minarelli engines.

*Sold singley*

High-quality replacement cylinder stud bolts for Minarelli/ Aerox.

Sold individually. M7 x 106mmMotoforce Part No. MF96.90012

Replacement flywheel side crankcase half for Minarelli/ Yamaha Aerox Engines.

Cylinder head bolt, nut set available in M6 or M7 thread 13mm long.

Choose M6 thread for all Piaggio based 50cc moped engines.

Choose M7...

Yamaha Aerox centre engine mount bush/ shaft. This is the long tube which goes though the middle of your engine cases which the swing arm...

Exhaust stud, nut and gasket set - this is the perfect kit for mopeds and includes the 3 main items you will need when fitting a new...

High quality steel M6 flanged bolt, available in a range of different lengths.

These bolts are used all over all scooters and mopeds from...

Yamaha Aerox/ Minarelli oil pump drive wheel.

Oil pump dowel for Yamaha Aerox/ Minarelli bikes. This is the pin which drives the plastic oil pump wheel on the crank.

Note: Sold...

Oil tube/ Low pressure tube (semi-transparent)
2.5mm inside is the pipe that goes from the oil tank to feed the oil pump.
4mm...

Cylinder head water caps for Yamaha Aerox/ Minarelli Malossi cylinders.

Standard Aerox has 2 small pipes running from the cylinder head to...

47mm - liquid cooled 70cc cylinder head for Yamaha Aerox/ Minarelli liquid cooled engines, these are designed for the DMP 70cc cylinder...

Motoforce oil seal clamp for Yamaha Aerox/ Minarelli engined scooters.

This is the clamp which holds in the crank oil seal on the flywheel...

Genuine Yamaha Aerox oil tank. A straight replacement for the old standard part.

Thermostat for Yamaha Aerox/ Minarelli liquid cooled engines.

Made in Italy.

Waterpump bolt for Yamaha Aerox/ Minarelli engines.Screws into the flywheel to turn the waterpump wheel.

Sold individually

Nut M10x1.25mm for the crankshaft on the fly wheel side. Fits all Minarelli engines.Motoforce Part No. MF96.90000

Oil pump circlip for Yamaha Aerox/ Minarelli engines.

This is the circlip which goes on the crankshaft either side of the plastic oil pump...